80AMP 12V/24V 24h-Backlight Solar Panel Cell PV Charge Controller G80

80A 12V/24V Solar Panel Cell PV of Charge Controller with Backlight and full Display G80


1.24H backlight display
2. An interface displays all the data
3. Easy to use
4.LVD,LVR,SOC,Charging Current
  G series solar controller is designed for off-grid solar system, such as street light, solar home system or small power station etc. It has LCD display, reliable battery charging , full electronic protection, and programmable parameters.

 Highest Reliability
High efficient Series PWM charging
Fully Adjustable
Backlight LCD
Intelligent lighting and timer control for solar lighting system
Four battery type options: Sealed, Gel, Flooded, and USER
Multiple load control modes
Battery temperature compensation
LCD displays voltage, amperage and battery percentage of
charge(Battery SOC)
Backlight LCD
Easy operation interface
Easy to Reset  A key to open and close the load
Longer Battery Life  Only install the regulator near the battery on a suitable surface. This surface should be solid, stabile, even, dry and nonflammable.
 
The battery cable should be as short as possible and have a suitable cable diameter size to minimize loss, Recommended: 30A current 10mm2  60A current 20mm2  80A current 25 mm2  cable.
 
Do not install the controller to direct sunlight.

If the solar battery will be operated under a large temperature range (winter/summer) the external temperature sensor should be used. A temperature compensated final charge voltage will extend the batteries lifetime and uses the optimum charge capacity.
 
To ensure the air convection on each side keep a distance of 10 cm to the regulator. The temperature at the installation site may never fall below or exceed the maximal permitted ambient temperature.
 
Connect the individual components to the symbols provided.
 
Observe the following connection sequence during commissioning:
1. Connect the battery to the charge regulator - plus and minus
2. Connect the photovoltaic module to the charge regulator - plus and minus
3. Connect the consumer to the charge regulator - plus and minus
 
 
The reverse order applies when uninstall!
Please observe that the automatic adjustment to 12V/24V systems does not function properly,if this sequence order is not followed. An improper sequence order can damage the battery!
 
 
*CAUTION*
Always disconnect the solar wires from the charge controller before disconnecting the battery wires from the charge controller. Remove any jewelry that may cause a connection between battery terminals. Safety glasses are recommended.